May Blossoms Stitch Along: Part 4
Fill in the last part continues from this point. Let's finish the project we've been working on step by step for the past month. I saw some of your work, thanks a lot for sharing it with me. You have done a miracle. I can't wait for the end result :)
Now, no more, let's dive into sewing.
The last part corresponds to the third flower. I recommend trying the long and short diagonal points of this flower, which are a little trickier than the usual up and down movement.
In this article I've provided a quick tutorial on long and short diagonal points, so it would be a good idea to read on first - maybe use the same egg.
իկան technical points that we will be using in this section: striped point, long point, short point , French knot , split point, satin point .
You can see the previous part here.
Let's go!
1). Use the color A և the dotted line on the left thread for each petal. Then fill in the long and short dots on the left of this color by adding a few dots (of the same color) on top. The upper frets were marked by two cuts, to make it easier to reach the higher frets.
2). Take color B , start adding rectangular dots on the edges of the leaves (there are dots in this corner slanting in different directions; please don't get confused, these dots refer to the egg, I'll cover them long or short). points later. You can compare the second step with the fourth step to see if it is hidden.
3). Add the dots of color B on top of the petal, mix them with the dots of color A at the top left, and run over the area of color A at the bottom left. It should remind you of a diagonal line.
4). Take color C , thread 1 on the needle, make another diagonal color line that should cover most of the petals. You can leave some space on the right to comfortably add a few points to the next color.
5). We finish this petal with the color D - add a few dots on the right next to the other petals under petal և.
6). Now, when we comb color E , using two threads, we can divide the folded flower petal part. Next, change the thread with 1 satin stitch . Everything is as in the second part. It is recommended to start the satin seam from a small end, and then gradually fill both sides.
7). After transferring the design to my fabric, I pinned the egg to the folded portion of the pattern. So don't be surprised by the difference.
8). Finally, let's fill the center of the flower with a French G -shaped knot . Make two loops for the middle knot և one loop for the petal knot.
to this degree.
Here is my gallery below, I look forward to seeing your beautiful work :)
